CGM+ DataField

Shows your glucose value as a data field during an activity, such as a run or a ride. It also saves your glucose to the activity, so you can see it in Garmin Connect afterwards.

What you need

  • A CGM that shares its readings online or on your phone: Dexcom (Share), FreeStyle Libre (LibreLinkUp), Nightscout, xDrip+, Juggluco, AAPS or Spike.
  • Your phone near your watch and connected to it. The data field gets its readings through your phone.
  • You don't need the CGM+ GB watch app. The data field gets its own readings and has its own settings. It uses the same login, so the CGM+ GB setup guides work for it too.

Set it up

1. Install the data field

Install it from the Connect IQ store and let it sync to your watch.

2. Get your CGM ready

Follow the guide for your system, up to the point where you enter your details:

3. Enter your details

In the Connect IQ app on your phone, go to My Devices → your watch → My Apps → Data Fields → CGM+ DataField → Settings. Choose your CGM System and fill in Username / URL and Password / Access Token. For xDrip+, Juggluco, AAPS and Spike you leave both empty.

4. Add it to an activity

On your watch, open the activity you want, for example Run. Go to its settings → Data Screens, pick a screen and a field, and choose Connect IQ → CGM+ DataField. The exact menu names differ a little per watch.

5. Start the activity

The field shows wait... until the first reading arrives. After that it gets a new reading about every 5 minutes, just like your CGM.

What it shows

The field is called CGM+ and shows your latest glucose value. If you turn on Show Trend, a sign after the value shows where you are heading:

++ rising fast, + rising, = steady, - falling, -- falling fast.

The field doesn't show how old the reading is. If the value doesn't change for a while, check your CGM app.

After the activity, Garmin Connect shows a CGM Glucose chart, your Avg, Min and Max Glucose in the summary, and the average per lap.

Settings

Change these in the Connect IQ app, see step 3.

SettingDefaultWhat it does
CGM System Dexcom US Where your readings come from: Dexcom US, Outside US or Japan, Nightscout, FreeStyle Libre / LibreLinkUp, xDrip+, Juggluco, AAPS, Spike or Nightscout Direct. Test Mode shows test data, handy to try the field.
Username / URL Empty Dexcom or Libre: your username. Nightscout: your Nightscout address. xDrip+, Juggluco, AAPS, Spike: leave empty.
Password / Access Token Empty Your password, or your Nightscout token.
Units mg/dL mg/dL or mmol/L.
Decimals display Automatic Automatic shows one decimal for values below 100 and none above. Using mg/dL? Choose No Decimals.
Show Trend Off Adds the trend sign after the value.
Stale data cutoff (minutes) 15 When the field starts, it doesn't show a saved reading older than this.

Troubleshooting

  • It keeps showing wait...: no reading has arrived yet. Check that your phone is connected to your watch, and give it a few minutes.
  • It shows Error: No Connection: your watch can't reach your phone, or your phone has no internet. With xDrip+, Juggluco, AAPS or Spike, check that its web server is on.
  • It shows another Error: message: usually a wrong login, URL or CGM System. Check step 3, and see the CGM+ error codes and FAQ.
  • You can't find it under Connect IQ on your watch: check that it synced. Open the Connect IQ app and look under My Apps → Data Fields.

⚠️ Important Disclaimer

  • NOT FOR MEDICAL DECISIONS: This app is for informational purposes only and should NOT be used to make medical decisions.
  • Always verify readings: Confirm glucose values with your official CGM receiver or app before taking action.
  • Emergency situations: In case of extreme glucose levels or medical emergencies, use your primary CGM device.
  • Delayed data: Readings may be delayed by several minutes due to how often the app can sync.
  • No liability: The developer assumes no responsibility for health outcomes related to the use of this app.
  • Not affiliated: This app is not approved by, endorsed by, or affiliated with Dexcom, Abbott (Libre), or any other medical device company.