Frequently Asked Questions

Common questions about the CGM+ App for Garmin watches.

Q: How often does the CGM data update?

A: The app gets new glucose readings every 5 minutes, the same interval Dexcom uses. The timing depends on:

  • Phone connectivity to your watch
  • Garmin Connect app status (running or background)
  • Internet connection quality
  • Dexcom Share sync timing

The first update happens right away. The second one takes between 5 and 9 minutes, because the app lines up with Dexcom's schedule. Garmin only lets the app go online once every 5 minutes while in the background. To line up, the app reads when Dexcom last updated, and plans the next update 3 seconds after Dexcom's next expected update. After that a new reading comes every 5 minutes, in theory within ~15 seconds after your CGM has it. In practice it is usually every 5-8 minutes.

Q: What do the trend arrows mean?

A: Trend arrows show which way your glucose is moving, and how fast:

Arrow Meaning Rate of Change (Dexcom)
→ Steady -1 to +1 mg/dL/min or less than 15 mg/dL in 15 minutes
⬈ ⬊ Rising or Falling slowly 1 to 2 mg/dL/min or 15-30 mg/dL in 15 minutes
↑ ↓ Rising or Falling 2 to 3 mg/dL each minute or 30-45 mg/dL in 15 minutes
↑↑ ↓↓ Rising or Falling rapidly > 3 mg/dL each minute or more than 45 mg/dL in 15 minutes

Q: Will this work with Libre or other CGM systems?

A: Yes. The app supports several CGM systems and data sources, including Dexcom (G6/G7), Libre (LibreLinkUp), Nightscout, and xDrip+/AAPS/Spike.

Q: Does this work with Dexcom Stelo?

A: No. Dexcom Stelo doesn't work through Dexcom Share. For the current options, see the Introduction page.

Q: Does the app work without my phone nearby?

A: No. Your phone must be connected via Bluetooth and have internet. The app gets the CGM data from your source (such as Dexcom Share, LibreLinkUp, Nightscout, or xDrip+/AAPS/Spike) through your phone, not directly from your transmitter. When disconnected, the last known reading stays visible but doesn't update. How it looks depends on your Stale Data Warning and Stale Data Cutoff settings (see Settings).

Q: How much battery does the CGM+ App use?

A: Very little:

  • Typical impact: Less than 1-2% additional battery drain per day
  • Runs as a background service, not all the time
  • Makes network requests every 5 minutes
  • Uses no GPS or continuous sensors

Q: Can I get alerts for high or low glucose?

A: Not yet. The app has no alerts. I might add them in a future update. For now, use a more reliable way to get alerts:

  • The official app of your CGM on your phone (primary alerts)
  • Your CGM receiver, if you use one
  • The follower app of your CGM, for caregivers

Q: Why is my glucose reading different from my CGM app?

A: Small differences come from sync timing. The app can only update once every 5 minutes, so it can be up to 10 minutes behind.

  1. Check the "CGM Time" field to see how old the watch data is
  2. Check that your CGM app is syncing
  3. Check your internet connection
  4. Wait 5 minutes for the next update

Always trust your primary CGM device for medical decisions. Never rely on this app.

Q: Is my Dexcom password stored securely?

A: Your credentials are:

  • Stored on your watch only. My server stores no information: no login details and no glucose data
  • Sent over encrypted HTTPS, through my server, to Dexcom
  • Used only to log in to the Dexcom Share servers
  • Not accessible to other apps

As always, use a strong, unique password for your Dexcom account.

Q: Why is my password not working?

A: The Dexcom Share API says "invalid password" for several login problems. Common causes:

  1. Verify your credentials: Try them at uam1.dexcom.com (US), uam2.dexcom.com (Outside US), or uam.dexcom.jp (Japan)
  2. Select correct region: Pick the right Dexcom server region (US, Outside US, or Japan) in the app settings
  3. Username format: If you log in with a phone number, include the country code (e.g., +11234567890 for US numbers)
  4. Use main account: Use your own Dexcom login, not a follower's
  5. Enable Dexcom Share: Share only works with at least one follower set up in the Dexcom app

Checked all of these and still stuck? See the Error Codes page for more help.

Q: The app shows "---" on my watchface. What does this mean?

A: The CGM+ App isn't set up yet, or couldn't get data. To fix it:

  1. Open the Garmin Connect IQ app
  2. Go to: My Devices → [Your Watch] → My Apps → CGM+ GB → Settings
  3. Enter your Dexcom Share username and password
  4. Select the correct server region
  5. Save and sync to your watch
  6. Wait 5-10 minutes for the first data fetch

See the Installation & Setup guide for detailed steps.

Q: Can I use this app during activities/workouts?

A: Yes. Use the CGM+ Datafield app.

Q: What if I change my Dexcom password?

A: Update it in the Garmin app too:

  1. Open the Garmin Connect IQ app
  2. Go to the CGM+ App settings
  3. Enter the new password
  4. Save and sync to your watch

Until then, the app shows an "Auth Failed" error.

Q: Does this app work during airplane mode or without phone?

A: No. The app needs:

  • Bluetooth connection to your phone
  • Phone connected to internet (WiFi or cellular)
  • Garmin Connect app running

In airplane mode or when disconnected, the last known reading stays on screen but doesn't update.

Q: What is the difference between Nightscout and Nightscout Direct?

A: Both connect to your Nightscout site, in a different way:

  • Nightscout Direct: Connects straight to your Nightscout URL. Simpler, but Garmin's memory limits it to about 2 hours of glucose history.
  • Nightscout (with proxy): Sends the data through a proxy server that compresses it. That way your watch can show up to 24 hours of glucose history instead of 2.

Recommendation: Use regular Nightscout (with proxy) to see more history on your watch. Use Nightscout Direct if you prefer a direct connection and only need recent readings.

Q: Is any of my data used or stored?

A: No. All your personal data is stored only on your watch.

To show up to 24 hours of glucose history, your data passes through a service in the EU or US (based on your location). It makes the data smaller so it fits in the watch's memory.

Important: This service stores no data and leaves no traces. It only compresses the data on the way and sends it straight to your watch. Your credentials and glucose readings stay private and are never logged, analyzed or kept.

Q: Is this app free?

A: Yes, the CGM+ App is completely free. If you find it useful, you can support me through Ko-fi or the other donation links in the app description.

Still Have Questions?

More Help: See Error Codes or go back to the Introduction.

⚠️ Important Disclaimer

  • NOT FOR MEDICAL DECISIONS: This app is for informational purposes only and should NOT be used to make medical decisions.
  • Always verify readings: Confirm glucose values with your official CGM receiver or app before taking action.
  • Emergency situations: In case of extreme glucose levels or medical emergencies, use your primary CGM device.
  • Delayed data: Readings may be delayed by several minutes due to how often the app can sync.
  • No liability: The developer assumes no responsibility for health outcomes related to the use of this app.
  • Not affiliated: This app is not approved by, endorsed by, or affiliated with Dexcom, Abbott (Libre), or any other medical device company.